02-24-2013 02:17 AM - edited 03-18-2019 12:39 AM
Hi,
I have sx20 connected to 2 identical screens (same size, same brand- sharp, same settings), but there is diffrences in the video color and resoulution and is not the same in both screens.
There is any explenation for that? and what i can do about it?
Thanks,
Shy
02-24-2013 02:34 AM
Hi Shy,
You can define those settings by logging into the codec's API via Telnet/SSH. Video Output settings are located as:
*c xConfiguration Video Output HDMI 1 Resolution: 1280_720_60
*c xConfiguration Video Output HDMI 1 OverscanLevel: None
*c xConfiguration Video Output HDMI 1 CEC Mode: Off
*c xConfiguration Video Output HDMI 1 MonitorRole: First
*c xConfiguration Video Output DVI 2 Resolution: 1024_768_60
*c xConfiguration Video Output DVI 2 OverscanLevel: None
*c xConfiguration Video Output DVI 2 MonitorRole: First
I ran the commands on a C60 and hence you see a DVI 2. In your case it would show HDMI 2 (I suppose). Run xconfiguration Video Output and you would see all the output settings and their resolution. You can change those settings there. Also if you want them to be identical I would also recommend having both the monitor roles set to First:
*c xConfiguration Video Output HDMI 1 MonitorRole: First
*c xConfiguration Video Output DVI 2 MonitorRole: First
Again in your case, it would be HDMI 2 instead of DVI 2.
Hope this answers your question.
Thanks
Mubashshir Akhtar
TelePresence Solution Group
02-24-2013 02:37 AM
Thanks,
I'll check it
02-26-2013 03:02 PM
Hi Shy,
Please mark this thread resolved if this fixed your issue.
Thanks
Mubashshir Akhtar
TelePresence Solution Group
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: