Adding a Subscriber to CUCM 9.1 BE6K

[Arturo Jr. Pacardo]

Hello guys,

Good day to all of you!

I would like to ask if someone knows a certain topic or a link that would provide a step-by-step procedure on how to add a subscriber to a CUCM 9.1 BE6K?

We would like to configure a subscriber as a standby fail-safe for our CUCM, so that if ever something happens, the subscriber can still hold phone operations here in our office.

Any information that could help or even suggestions would be greatly appreciated!

Thanks!

Kind regards,

Art

Network Engineer
Net Pacific Philippines
CCNA R&S
CSCO12379161       

[ronpatel · Accepted solution]

HI

You can add subscriber like we do it for normal CUCM. Take the supported hardware, Take the DVD provided.. Install it and select no when it ask if this is 1st node in the cluster..after this it will ask for CUCM publisher details.. Give those details anre you are ready to go....

Regards
Ronak Patel

Rate all helpful post by clicking stars below the answer.

[Arturo Jr. Pacardo]

Hi Ronak,

Thank you so much for your fast response!

Will do as instructed, and if we might bump into something I hope you would be able to assist us.

Cheers,

Art

Network Engineer
Net Pacific Philippines
CCNA R&S
CSCO12379161

[ronpatel]

Hi

Yes why not, we are here to help only.

If you are Cisco certified partner and If you are stuck in any step, you can open Cisco PDI case and we will help you further. You can reach PDI team at cisco.com/go/pdihelpdesk.

Regards
Ronak Patel

Rate all helpful post by clicking stars below the answer.

[Rejohn Cuares · Accepted solution]

Hi Arturo,

If you get stuck just follow this guide:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/install/9_1_1/CUCM_BK_I05CD008_00_installing-cucm-91_chapter_01.html

Adding subscriber is straight forward. Good luck.

Please rate replies and mark question as "answered" if applicable.

[Arturo Jr. Pacardo]

Hi rr,

Thanks to you too!

Cheers,

Art

Network Engineer
Net Pacific Philippines
CCNA R&S
CSCO12379161