Hello, I have installed a new CUCM v14 and want to import the configuration of an older cluster v11.5. I have installed the ciscocm.DataExport_v1.0.cop.sgn file on the old cucm publisher. When I run the Utils system upgrade dataexport initiate comm...
I need to upgrade CER from 11.5 to 14 and have access to three ISOs. Does anyone know which I should use for this purpose, or is there a different one I need? 14.0.1.10000-7-recovery.isoBootable_UCSInstall_CER_14.0.1.10000-7.sha512.isoUCSInstall_CER_...
Hello, I am looking for step by step procedure for installation, configuration, integration Cisco Unified Attendant Console Advanced with CUCM 14. Also need to know from where to download CUACA 14 Server and client setup. If possible also please ment...
I support 20 school campuses, three additional buildings, and various departments within the administration building. I am using user templates to set the Caller Input for 0 so that the Operator extension points to a receptionist or secretary nearest...
Hello, I've been tasked with repairing a non-working fax line. I do know the full phone number in question and that it is a DID number. Is there a way in CUCM to find the number or any information about the number in question. The closest that I've b...
ON CUCM 14SU3 EnableJabber2TeamsMigration does not show up i policies on jabber configuration file. Any idea why?it shows on https://www.ciscolive.com/c/dam/r/ciscolive/emea/docs/2024/pdf/BRKCOL-2062.pdf
A change was recently made on one of our Rightfax Servers to use G.711 instead of T.38 and outbound faxes now drop at 15 minutes (change was made to avoid ongoing T.38 issues with transmission errors)We see the initial outbound invite where the fax e...
Hello, We have an issue for outgoing calls through a PRI (MGCP). Call Manager is sending the Display (Caller ID), instead of the ASCII Display (Caller ID) for all external calls. Do you have an idea?
It's been a little while since I used PCD and wanted to double check a couple of questions (this is a 10.5 to 15 migration): 1.) If I'm reusing the same hostname and ip addresses (or different hostname but same ip) from the existing CUCM cluster, can...
Hi Everyone I have some issues after upgrading from CUCM version 12.5 to 15 SU1, the NTP appears warning as unreachable. I tried to check the status in the cli, but the status is stopped but if I try to start the service the status service is runnin...
Hello, I just received some new 9851 and 9861 phones and cannot get the phone services to connect with jabber. I have CUCM 12.5.1.14900-63 and IM and Presence is 12.5.1.14900-4
I'm struggling to find the instructions on how to install a CA signed HTTPS certificate to PCD. Can anyone point me at the right place?Thanks,Gordon
Hello. I will have a small branch of 3 to 4 offices where I need to provide VoIP phones. These phones will only be able to call between offices. They will not be able to call outside. I am considering recommending Cisco Unified Communications Manager...
Planning a CUCM and CUC upgrade using the Fresh Import Install. It's version 11.5 and also has a UCCX 11.6 attached to it. Couple of questions. 1) Are you supposed to run the upgrade export on all the nodes in the cluster? Then on the install run the...
I have experienced, that the correct inbound dial-peer is not selected, and the call not sent to an outbound dial-peer. I'm using are rather long list, that seems to kick in, even though there is no match there but a match in another list with a wild...
