Hi, I always configure the Voice Gateway for Fax with:,voice service voip fax protocol t38 nse version 0 ls-redundancy 0 hs-redundancy 0 fallback pass-through g711ulaw But I have a new issue, the Fax doesn't work with the T.38 configuration.From the...
Forum Posts
Hi all,i have a situation here, i have one technical support no (1001) which is available ( reachable ) to everyone in my company, i want now make 2 departments (Sales and Purchasing ) when they call 1001, convert them to auto attended ( thanks to c...
Hello,Has anyone experienced this issue? I have an SX80 that sees the display as a 1920x1200 resolution this leaves a border top and bottom. The second output connected to the same type of display sees the EDID information as 1920x1080 and does not h...
Hello All, I could not enable APNS feature on Call Manager (12.5) .I tried to enable this all the ways but no luck. Please assist. Push Notification/Activation Code Onboarding Settings cannot be configured as a valid certificate is not present in tru...
We have CUCM 12.5 test cluster with 4 server (3x CUCM and 1x IMP Server). We were trying to deploy the SSO on it and it failed. After that the CUCUM Admin page is not accessible for one server with error HTTP Status 404 ?. /ccmadmin/localauthlogin. ...
Hi everyone, I receive an old DX80 from a friend and the touchscreen is totaly dead. He unfortunately d'ont know how to connect a mouse. When i use a keyboard, he recognised Ctrl+alt+del and immediatly reboot. I d'ont know what to do.... i have skip ...
Hi All,How can i find the device defaults of end points for any CUCM release from release notes.All i get is device pack information only. I want to compare device defaults of CUCM 11.5 and 14SU1 to compare if any new device added in between these re...
Resolved! Cisco Jabber 11.7 xml generator
Hi all, i'm looking for the Cisco Jabber file generator xml, i need to use for Jabber 11.7 for windows . I'll register internal and external jabber client to cucm via expressway. thanks
Hello all,My costomer demand me the softkey DND in the phone cisco 8851 , when i applicate the correct softkey contain dnd , it's not displayed in the phone , after analyse i checked that cisco phone has this message in the firmware:Inactive Load Fa...
When we use uni-cast music on hold with call manager and we select the same device pool for endpoints ; we have found the continuing stream for last hold (initial hold) when we start the second hold so; When we changed device pools (without any relat...
hello please i need call manager support 10000 users which model you recommend for that .
A little confused about this procedure and would kindly ask for some guidelines.For an existing setup CUCM v12 with SA and with support that is expiring, the need is for renewal support, but also upgrade to v14.What would be the way to follow?It's cl...
Hi,I am trying to setup something like this;call extension 5678 (Hunt Pilot) - Audio prompts gets playedCalls gets forwarded to a group of users ( Line Group)When not awnsered/no one logged in - Call goes to voicemailQuestion is, I i can send the cal...
I have two broadband. My main one runs @ 80mbps. Whenever I answer a call, the whole PC gets disconnected so I can never use that for work unless I'm only doing outbound calls. I work as a helpdesk support for Australian clients so the nature of my w...
In a customer installation, the MGCP voice gateway is connected to the PSTN via an E1 voice circuit.Lately, without any reboot, it loses the clocking setting.The E1 controller setting changes from "clock source line primary" to "clock source line ".T...
