Unified Communications Infrastructure

Hi all. I'm running CUCM 8.5.1.10000-26 and am building a Presence server (8.0.4.10000-5) to intergrate with it.I've installed presence and followed the books to   integrate the two and everything has woked fine except for the last step   when I've g...

Hi,I have downloaded and installed UCSInstall_UCOS_8.0.3.20000-2.sgn.iso from cisco downloads to upgrade my Cisco Unified Communication Manager 7.1.2 now i have the license for 7 version only.  To get the License of 8th version i have to order the me...

Hello,We are using the CuciLync client with Microsoft Lync. We are able to make/receive calls, etc successfully, so the installation is working fine however we are unable to dial from 'smart tags' inside Internet Explorer and MS Office applications. ...

Hello everyone,In Active Directory all the users are setup with their full E.164 address.  I am looking for a way to filter this down to 4 or 7 digits using a LDAP Filter when importing users into CallManager.  Is it possible to do this?  If so, does...

Hi,How to register the TANDBERG with cisco unified communication manager 8.0.3?Thanks,

CUCM Version 8.5CUC Version 8.5- 10 digit enterprise dial plan- 4 digit dial plan available within local sitesWe have a site that uses an AA to direct calls. The AA is a Subscriber and the AA message says, "...or dial the 4 digit extension of the par...

Has anyone performed this successfully?  Also, I can't seem to find a documentation for disaster recovery or rebuild of Unity 7.We are running Cisco Unity 7.0 build 7.0(2) on our secondary server.  The server fails to boot from the C drive and always...

All,using CUPC 8.5(1) on UCM 8.5 and using dialing from within Outlook the call goes out fine but if you go back into the Conversation History instead of the user seeing the actual number that was dialed they see "Conference" listed.  They can't re-d...

Is there a way thru CM to reboot all phones? We just applied a patch to CM and are now seeing some lag time when a new phone first boots up and see it applying and update on the phone.

Has anyone witnessed a behavior in TMS where a booking type of Reservation will actually take action and send a command out to the end point and drop a current connection? We have times where our users will start a point to point call a few minutes ...