Unified Communications Infrastructure

HelloI have a small location using  cisco 1760, where is only 3 ip phones attach to our main call manager  6.1. That location has H323 trunk with the CCM 6.1 but the router 1760 has vic2fxo card with 2 lines, The issue is when someone call to that of...

Hi all,One quick question here.I am entitled to perform tests against a CUBE, with the platform our company develops and sells.Today I have no knowledge on CUBE but with hands-on and some examples I know I will be able to understand how it works, and...

Hello,I was looking at the CER Switch Port details and noticed there is a device on one of my switches that is not showing in the CER switchport database. THe phone is functioning properly and I do not appear to be having any other problems except t...

Hi,while configuring B-ACD 2.1.2.3 on IOS 12.4.15T13 I ran into two issues:with a voip dial-peer targeted to a loopback adress a single call will trigger the queue length (and therefore the display on the phones) to 2and a TCL failure may occure when...

Hi!Did someone manage to get the integration to work?MeetingPlace 7.x. and LotusNotes 8.5.x ?We can't manage it. The mail templates, which are in the MP 7 LN integration, do not work with LN 8.5Any suggestions or maby already working templates?

Hi All,i am new with CUMA so i need to know high level feature CUMA & CUMC provide that we can encourage our customer for this product.your help is much appreciateThanks,

I have a set of guards who work different shifts, each with their own email address.  I would like to enable an onsite alert for each guard's email, but not alert the phone.  In CER 7.x I see you must enter a phone number,  all of the guards share th...

Hi,We are having problems in the integration of the new MCU 5110 as "Conference Bridge" in the CUCM. The MCU is registered in the CUCM with we cannot use the ad-hoc feature on the phones. Once me make the video Call between two phones everyting is fi...

I have a customer currently on Unity voicemail only going to unity connection. since the existing is a simple config i wont be using COBRAS, but rather manually configuring their new system. Is it possible to build the unity connection out in my stag...

Hello,I just installed CUCM 7.1.3 in my test lab and also have got CCME 7 on cisco 2811(IOS version 12.4(24(T)).On CUCM 7 I have got range of number 6000-7000registered phone 6000ON CCME I have got 2000-3000registered phone 2000normaly in order to ca...

Got an existing cluster (6.1.4) that has a dial plan problem. The Line has a partition with an unfiltered 9.@, and the device has a partition with route filter 9.@ with route filter for Emergency calls (needed to ensure correct routing as all users a...

Dear readers,This is my very first post, so I apologize for any newbie behavior that could show up in this post!We have a 2 node cluster of Cisco Unified Callmanager 5.1.1 and we have been facing issues with CAR, the problem seems to be the following...

Hi, in this days I try with integration in object, i have interconnect the pbx hipath 8000 in sip trunk with cucm 7.0, the ccbs (call back, call completition on busy) don't work, i think it's not supported (why?) the other supplementary service are o...

Hello,I am working with a customer who currently has ~6000 users on a network consisting of a mix of model 30, 70 and 80's using cornet package 9006.6 with Phonemail 6.4.3. The customer is moving ~550 users to two new locations and is looking at what...