01-29-2023 04:58 PM
Hello, everyone
I have a question,
Voice Gateway Devie ISR4331/K9 have 2 slots,
So, ISR 4331/K9 use NIM-8MFT-T1/E1 * 2??
Solved! Go to Solution.
01-29-2023 09:23 PM
@SeungHyeon IM ISR 4331 does not support NIM-8MFT-T1/E1.
You can use up to 3 NIM-4MFT-T1/E1 modules which gives you a total of 12 T1 or E1 lines.
Please also see table below
03-14-2023 11:57 PM
I never tried this and i couldn't find a supporting document. ISR 4331 does support NIM-8MFT-T1/E1 so I believe you can add two 8E1.
I would never recommend adding 16 E1 lines in a single router i would always prefer to split them on two gateways.
01-29-2023 05:36 PM
I moved this post since this group is much more likely be able to assist you than the contact center one.
01-29-2023 09:23 PM
@SeungHyeon IM ISR 4331 does not support NIM-8MFT-T1/E1.
You can use up to 3 NIM-4MFT-T1/E1 modules which gives you a total of 12 T1 or E1 lines.
Please also see table below
01-29-2023 09:44 PM
Thank U so much
You r my hero
01-30-2023 07:54 AM - edited 01-30-2023 07:57 PM
ISR 4331 does support NIM-8MFT-T1/E1. Asper the guide you must be on minum versions 3.10 / 17.3 / 20.3 to support 8MFT T1/E1 on isr 4331.
I assume that you are referring an OLD data sheet.
03-14-2023 10:48 PM
Hi, Nithin Eluvathingal
So, ISR4331/k9, Can used 8E1 * 2 configurable?
03-14-2023 11:57 PM
I never tried this and i couldn't find a supporting document. ISR 4331 does support NIM-8MFT-T1/E1 so I believe you can add two 8E1.
I would never recommend adding 16 E1 lines in a single router i would always prefer to split them on two gateways.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: