cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
420
Views
0
Helpful
2
Replies

CUCM 10.0 Pub+Sub License

GUNGIT2012
Level 1
Level 1

Hi,

I have a question about the license of CUCM and CUC as below:

We have 2 CUCM 10.0 (1 Pub+1 Sub) and 1 CUC, CUCM and CUC licenses have been added to PLM of Pub, it is working normally when I open Cisco Prime License Manager of Pub, but Sub and CUC are working on the demo mode of Cisco Prime License Manager, Do I need to add the CUCM and CUC license to PLM of Sub and CUC?

 

Thanks

 

2 Accepted Solutions

Accepted Solutions

Jaime Valencia
Cisco Employee
Cisco Employee

Choose one PLM to use, install the licenses on it, then register all your products to it, you don't need to use all the PLMs that get installed 

HTH

java

if this helps, please rate

View solution in original post

Terry Cheema
VIP Alumni
VIP Alumni

I am guessing you mean, you have added Pub and CUC on the PLM on your PUB and uploaded your licenses there and its fine. But if you to Sub and CUC PLM it shows PLM is operating in DEMO mode.

This is completely normal. You have to use one PLM only.

-Terry

View solution in original post

2 Replies 2

Jaime Valencia
Cisco Employee
Cisco Employee

Choose one PLM to use, install the licenses on it, then register all your products to it, you don't need to use all the PLMs that get installed 

HTH

java

if this helps, please rate

Terry Cheema
VIP Alumni
VIP Alumni

I am guessing you mean, you have added Pub and CUC on the PLM on your PUB and uploaded your licenses there and its fine. But if you to Sub and CUC PLM it shows PLM is operating in DEMO mode.

This is completely normal. You have to use one PLM only.

-Terry