01-11-2021 03:24 PM
Excuse the ignorance...noob
I'm not sure this is possible, but is it possible to see what number is assigned to an incoming PRI line/port in CCUM? Trying to identify the PRI port that the main phone numbers is coming in on. I took a look at the 2911 & just see the basic config for the 2 voice-ports. Nada about number.
Hope this makes sense?
I appreciate the help & have a good day!
Regards,
James
Solved! Go to Solution.
01-11-2021 08:04 PM
To identify the port used by the DID block, use debug and you can see on which port it landed.
The below is from my lab and the call for DID range 200-299 land on interface Se0/1/0:15
debug isdn q931
Jan 12 04:02:34.109: ISDN Se0/1/0:15 Q931: RX <- SETUP pd = 8 callref = 0x20A1
Sending Complete
Bearer Capability i = 0x8090A3
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA1838E
Preferred, Channel 14
Calling Party Number i = 0x2183, '99028165'
Plan:ISDN, Type:National
Called Party Number i = 0xC1, '200'
Plan:ISDN, Type:Subscriber(local)
Jan 12 04:02:34.121: ISDN Se0/1/0:15 Q931: TX -> CALL_PROC pd = 8 callref = 0xA0A1
01-11-2021 08:04 PM
To identify the port used by the DID block, use debug and you can see on which port it landed.
The below is from my lab and the call for DID range 200-299 land on interface Se0/1/0:15
debug isdn q931
Jan 12 04:02:34.109: ISDN Se0/1/0:15 Q931: RX <- SETUP pd = 8 callref = 0x20A1
Sending Complete
Bearer Capability i = 0x8090A3
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA1838E
Preferred, Channel 14
Calling Party Number i = 0x2183, '99028165'
Plan:ISDN, Type:National
Called Party Number i = 0xC1, '200'
Plan:ISDN, Type:Subscriber(local)
Jan 12 04:02:34.121: ISDN Se0/1/0:15 Q931: TX -> CALL_PROC pd = 8 callref = 0xA0A1
01-12-2021 09:57 AM
Thank you!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide