CUE on Cisco 2921 ISR

[tkavithas87]

I cannot open the service module engine on the 2921 ISR.Is unity express is builtin with this?

The following are some commands related  this

2921#service-module embedded-Service-Engine 0/0 status

Service Module is Cisco Embedded-Service-Engine0/0

Service Module supports session via TTY line 2

Service Module heartbeat-reset is enabled

Embedded Service Engine boot state is RESET

No install/uninstall in progress

2921#service-module embedded-Service-Engine 0/0 se

2921#service-module embedded-Service-Engine 0/0 session

Trying 10.1.8.2, 2002 ... Open

2921#service-module embedded-Service-Engine 0/0 reload

Service Module not enabled, reload will not have any effect

[tkavithas87]

I have configured following on the router to enable this service engine

interface Loopback1

ip address 10.1.8.2 255.255.255.252

interface Embedded-Service-Engine0/0

ip unnumbered Loopback1

service-module ip address 10.1.8.1 255.255.255.252

service-module ip default-gateway 10.1.8.2

!

ip route 10.1.8.1 255.255.255.255 Embedded-Service-Engine0/0