cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2612
Views
10
Helpful
4
Replies

CUEAC Blind Transfers receive Invalid Destination

Kevin Martin
Level 1
Level 1

When attempting to blind transfer calls from an external source to an external destination, we receive "Invalid Destination".  We can, however, do a consult transfer without issue.  Calls are coming in and going out a pair of SIP Trunks to the PSTN.  Verified CSS are correct and have no issue dialing out.  Any Ideas?

CUEAC Version: 9.0

CUCM Version: 8.6

***Please Mark and Rate helpful posts***
1 Accepted Solution

Accepted Solutions

jamgale
Level 3
Level 3

What CSS did you verify?

When doing transfers CUAC does a "redirect", which means it is going to use the CSS of orignating device (Gateway). Make sure the CSS of the gateway has the correct access.

View solution in original post

4 Replies 4

jamgale
Level 3
Level 3

What CSS did you verify?

When doing transfers CUAC does a "redirect", which means it is going to use the CSS of orignating device (Gateway). Make sure the CSS of the gateway has the correct access.

The CTI CSS is what I verified.

So the Inbound CSS on the SIP Trunk needs to have the ability to dial out?

***Please Mark and Rate helpful posts***

That's correct, the call gets redirected from the original destination not the currently active device, therefore the SIP Trunk is what needs the access.

This is changing in V9.1 which is set for release in late April where it will use the current active device CSS.

Thanks, That fixed it.

***Please Mark and Rate helpful posts***
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: