02-13-2017 11:34 AM - edited 03-19-2019 12:06 PM
Has anyone set this up successfully yet?
I have followed the brief config included in the doc starting on page 53, but I am not having much luck.
See attached Doc S4BFED.pdf for config that works.
12-28-2017 12:08 PM
02-08-2018 11:32 AM
Thank you for this doc. I like it.
I am not sure that this is working right for me.
I followed directions.
In order to get the new IMP zone on Expressway C I had to use port 5061. when in port 5062 I get the following errors -
tvcs: Event="Outbound TLS Negotiation Error" Service="SIP" Src-ip="<removed>" Src-port="25115" Dst-ip="<removed>" Dst-port="5062" Detail="tlsv1 alert unknown ca" Protocol="TLS" Level="1" UTCTime="2018-02-07 22:07:45,321"
Certs from CUPS server, Expressway C&E server have been loaded into all servers.
Ideas on where things might be wrong?
I can't seem to chat yet...
-Mike
02-08-2018 11:25 AM
I am not sure that this is working right for me.
I followed directions.
In order to get the new IMP zone on Expressway C I had to use port 5061. when in port 5062 I get the following errors -
tvcs: Event="Outbound TLS Negotiation Error" Service="SIP" Src-ip="<removed>" Src-port="25115" Dst-ip="<removed>" Dst-port="5062" Detail="tlsv1 alert unknown ca" Protocol="TLS" Level="1" UTCTime="2018-02-07 22:07:45,321"
Certs from CUPS server, Expressway C&E server have been loaded into all servers.
Ideas on where things might be wrong?
I can't seem to chat yet...
-Mike
.
07-11-2018 04:11 AM
I had this working in my lab perfectly between CUCM- IMP 11.5.1 SU4, Expressway 8.10.4 and Skype for Business, I have since built a new CUCM - IMP 12.0.1 and migrated the same Expressway to the new CUCM - IMP, I now have chat both ways but only presence in the S4B client for Jabber, Jabber does not see any S4B presence.
Anyone else configured this with 12 yet?
08-17-2018 02:43 AM
The same issue here - CUCM - IMP 11.5.1 SU5 - Expressway 8.11 - IM works, Presence one way only. The Skype Client (Office 365) can view the presence status the Jabber always show offline ...
Any ideas?
02-13-2019 06:32 AM
Hi Frank
Did you get this working , I have another deployment with O365 S4B client and again can only get presence one way, S4B can see Jabber but Jabber sees none.
05-23-2019 07:54 AM
I also have this issue--IM works in both directions, but presence only works in one direction; Jabber users can't see presence on any of the S4B users.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: