Failed to setup cbarge

[ryancdavis]

Hi,

I'm using cme 7.0.3, and have setup cbarge. However when the remote in use softkeys appear, and I hit "cbarge", I receive a "failed to setup cbarge" messages. Anyone have any ideas?

Thank you.

[Rob Huffman · Accepted solution]

Hi Ryan,

Just a couple of questions here :) For SCCP phones cBarge is only supported on Octo-Line DN's, are you using Octo-lines? Second question, are you using a hardware Conference bridge?

Barge (Conference Barge)

The Barge feature enables phone users to join a call on a shared octo-line directory number by pressing the Cbarge soft key and converting the call to an ad hoc conference. This feature uses a hardware conference bridge configured in Cisco Unified CME. When the initiator barges into a call, an ad hoc conference is created between the barge initiator, the target party, and the other party connected in the call. Parties see the call information on their phone displays and, if the conference join tone is configured, hear a tone.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmebarge.html

Cheers!

Rob