cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2121
Views
0
Helpful
3
Replies

Outbound calls showing 408 temporarily unavailable

SPoodari
Beginner
Beginner
3 Replies 3

Nithin Eluvathingal
VIP Mentor VIP Mentor
VIP Mentor

Could you please provide a little more information regarding your setup actual issue etc.. 



Response Signature


Roger Kallberg
VIP Expert VIP Expert
VIP Expert

Most people here are going to go into length to try to help you out, but we’re not magicians. You would need to provide a little bit of more information than what you have done up to this point.

To start with describe your setup and your system landscape, then provide your current configuration and the output from debug ccsip message. With this we’d have a sporting chance to give you some help along the way.



Response Signature


Sadav Ansari
VIP Rising star VIP Rising star
VIP Rising star

Share debugs and setup as suggested @Roger Kallberg and @Nithin Eluvathingal .

 

First thing need to check your outbound css in your sip trunk configuration that means which partition you are dialling that should be contain on your sip trunk outbound CSS configuration and on your end device line CSS.

 

Pls rate if its “Helpful”. If this answered your question pls click “Accept as Solution”.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: