cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1246
Views
4
Helpful
3
Replies

Route Outgoing Call to Specific Voice Port

igo.gunawan
Level 1
Level 1

Hallo,

I have CME 10.5 with 2 PSTN lines.

There is combination of SIP & SCCP phones here. How if I want to route an outgoing call from a SIP phone to a voice port?

Thanks.

1 Accepted Solution

Accepted Solutions

Below link should help you in achieving your requirement;

https://supportforums.cisco.com/discussion/12738046/cme-3-analog-lines

- Vivek

View solution in original post

3 Replies 3

Vivek Batra
VIP Alumni
VIP Alumni

Simply create outbound dial peer and attach it with specific voice port (using port command), however if your requirement is that only specific set of phones should be able to call from first PSTN line and remaining phones from other PSTN line, then you would like to check Class of Restriction (CoR).

- Vivek

Hi Vivek,

Yup, I actually need to route some phones (SIP) to specific PSTN line, and some other phones to other line.

I'll try COR if that's the only way.

Was thinking about trunk, but I think that applies to SCCP only.

Thanks.

Below link should help you in achieving your requirement;

https://supportforums.cisco.com/discussion/12738046/cme-3-analog-lines

- Vivek