SkyStone with CUCM 8.5

[lalqatta982011]

I have CUCM 8.5 and recently I purchased the SkyStone software. put I got difficulty to integrate the SkyStone with CUCM.

could you please send me a step by step guide for this integration.

Regards,

[qmohamme]

I am not sure if you would find this documented on CCO or CCE. I would rather advise you to check with imagicle directly.

-Qader

[gbmservices]

GUYS!!!  if you find solution for integrating Skystone with CUCM 8.5 . Please post here. I am trying to create a H323 trunk to skystone software and then trying to route the call through skype.

[Christian Bongiovanni]

Dear Suarj,
you can refer to the docs on imagicle web site.

H.323 trunk and relative Route Pattern should be enough to call to SKyStone (so to Skype) from a Cisco phone.

For calls getting in from Skype to Cisco phones, you also need to set the right inbound CSS on the trunk (gateway).

If you can't figure the problem out, please open a case to support@imagicle.com

Looking forward to getting back from you.

Thanks

Christian Bongiovanni co-CEO and Chief Technology Officer M +39 348 1302880 skype: christian.bongiovanni Imagicle spa Via Fratelli Di Dio, 2 - 20013 Magenta (MI)  Italy T  +39.02.25067711 - F  +39.02.25067799 e-mail: info@imagicle.com - web: http://www.imagicle.com