UC500 series platform with 262144 Kbytes of main memory
Readonly ROMMON initialized
With some search online I found and downloaded full UC500 software pack UC540-8.6.2
Extracted but I do not know how to load image on UC540 and which files I should load to CF. Well just to try it, I connected Ethernet cable to port 1 on UC540 other end to my laptop, but I don't have any NIC activity. My laptop nic shows no cable plugged in (btw all 8 ports are solid green on UC540 maybe it is hardware failure?). Well, I will move forward just to see what happens. So I found couple guides, how to load new iOS on Cisco device. Used TFTP and tried to load cue-installer.uc500.8.6.5 to CF memory just to see what happens. This is what I ran in rommon:
Invoke this command for disaster recovery only. WARNING: all existing data in all partitions on flash will be lost! Do you wish to continue? y/n: [n]: y ........... ARP: address resolution for 10.0.1.107 timed out. ARP failed with failure code 1. TFTP transfer aborted.
So this tells me that I don't have network connectivity, to load image via TFTP, am I using wrong port on UC540 why I don't get NIC activity?
So couple questions which I can't figure out:
what would be a proper way to load needed files on CF card, would card reader work?
Which files should be on CF card to get UC540 to factory defaults?
What steps should be performed to get it to factory defaults, that I could continue Quick configuration guide from step download CCA Cisco configuration assistant and Connect an Ethernet cable to one of the PoE ports on the front panel of the UC 540.
I am hitting a wall and can't find any info to move further. Any docs, links with info to clear the clouds would be helpful.