cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
958
Views
0
Helpful
2
Replies

UCCX IP Phone Agent State Question

When using IP phone agent there is a system parameter to have the default agent state after a Ring-No-Answer event to default to Ready or Not Ready (it's not ready by default).  Is there a way to alter this behavior at any level other than system wide?    I need this to happen only for specific phones (or it could be at the CSQ or group level).  I do NOTwant to change the behaviors system wide. 

Failing that, is there any way or any other place where I can force an agent state to ready after a ring-no-answer (scripting or other)?

NOTE: The IP agents are loggin in using the one-button technique rather than the default BIPPA method.

--Chris

1 Accepted Solution

Accepted Solutions

Chris Deren
Hall of Fame
Hall of Fame

Chris,

Unfortunately, System level is the only way.

HTH,

Chris

View solution in original post

2 Replies 2

Chris Deren
Hall of Fame
Hall of Fame

Chris,

Unfortunately, System level is the only way.

HTH,

Chris

That's what I thought, but I wanted to see if anyone had a work around.  Thanks!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: