cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1366
Views
0
Helpful
6
Replies
Contributor

Attendant Console transfers showing CTI port DN

Hi all,

We have recently installed an Attendant Console 9 server which is all working fine. However, when a call comes in to the Console and operator transfers it off to an internal extensions, users are reporting that they see the CTI port DN on their phone when it rings, then when they pick up and the call is connected, it then shows the original calling number?

Is this by design? Is there a way I can have the original calling number displayed to the users phone when the call gets transferred?

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

Attendant Console transfers showing CTI port DN

Yes, this is by design. The CUxAC server remains in the call path until it connects in case it needs to pull it back. You can change the behavior to a direct transfer using a registry setting on the client computer (not the server).

Please remember to rate helpful responses and identify helpful or correct answers.

View solution in original post

6 REPLIES 6
Highlighted

Attendant Console transfers showing CTI port DN

Yes, this is by design. The CUxAC server remains in the call path until it connects in case it needs to pull it back. You can change the behavior to a direct transfer using a registry setting on the client computer (not the server).

Please remember to rate helpful responses and identify helpful or correct answers.

View solution in original post

Highlighted
Contributor

Attendant Console transfers showing CTI port DN

Thanks Jonathan. I had a look for the key on that link, but couldn't find it.

I can browse to HKLM>Software>Arc Solutions>Call Connect>Operator>Defaults> but there is no "Direct Transfers" entry in the list. Should I create a new key? If so, what is the correct format?

AC is CUEAC 9.0.1

Thanks

Sean

Highlighted

Attendant Console transfers showing CTI port DN

Yeah you have to create it; Reg_SZ if memory serves.

Highlighted
Contributor

Attendant Console transfers showing CTI port DN

Thanks Jonathan,

Have looked on the user guide for v9 - http://www.cisco.com/en/US/docs/voice_ip_comm/cucmac/arc/CUACBE_V901_User_G.pdf (p.50)

It seems the same can be achieved from Preferences > Options > Advanced and setting it to "No calls"

Regards

Sean

Highlighted
Cisco Employee

Attendant Console transfers showing CTI port DN

Sean,

That is correct, the preference was added in V9 to make things easier.

Highlighted
Beginner

Hi Jonathan,We have CUxAC v9

Hi Jonathan,

We have CUxAC v9 installed at our offices. I have tried to make the registery change as suggested but each time we close and open the AC software the registry key  for Direct Transfer goes back to default ( off ) and idea on how i can get it to not do this as our users need the number to be displayed urgently...thanks very much

Andre

 

CreatePlease to create content