Auto Attendant in Unity Conn cannot transfer to ext
I have Unity Connection 9.x as auto attendant. The Unity Conn is not integrated with CUCM for user synchronization. Before i changed extension number from 3 digit length to 4 digit length, it was working fine. I've updated the extension number of each user in Unity Conn but the auto attendant is still cannot transfer to extension of Unity Conn user. Even i have checked the restrition table and unblocked pattern *, but still cannot transfer to Unity Conn user.
First, let's be sure I understand what has changed and what you're trying to do:
You changed the Primary Extension on user mailboxes from three to four digits
A caller reaches a Call Handler and enters the Primary Extension of a user mailbox
When the extensions were three digits this matched the mailbox and performed an Attempt Transfer to their CUCM DN
Now that you have changed the CXN extension to four digits, this same operation fails.
Second, what does CXN say when you enter the extension? If it didn't work there should be some prompt played back.
Assuming that is accurate, here are a few steps to get started:
Verify that the Caller Input page on the Call Handler is not prefixing digits to the input, effectivly corrupting the input
Verify that the input key for the now leading digit is not locked (i.e. will accept multi-digit input)
Use the Remote Port Status Monitor to see whether CXN is able to match a subscriber mailbox to the input. If it can't find a matching mailbox but you're confident that the value is correct, review the Partition/CSS within CXN (not CUCM) to ensure the mailbox is visible to that caller.
If a subscriber was matched but the attempt transfer operation failed, it's likely a problem with the CSS or patterns avaialble to CXN from CUCM. This is controled by the CSS applied to the ports/SIP Trunk. For example, there may be an urgent priority three-digit pattern that is getting matched and preventing CXN from calling the user.
The prompt that was played is "You cannot be transfer to this number, please consult your directory". I've checked the restriction table of System Transfer and System Default Transfer, and make sure new primary extension doesn't get blocked.
IntroductionFeatured ExpertQ:Under what circumstances does it make sense to view "resource total" as opposed to "resource available" or vice versa?Q:Can that be sent to a Syslog server?Q:Is it possible to see when a device has changed, for example, if a ...
(view in My Videos)
Community Live- Tour of the Real-Time Monitoring Tool
(Live event - Tuesday, 20 April, 2021 at 10:00 am Pacific/ 1:00 pm Eastern / 7:00 pm Paris)
This event had place on Tuesday 20th, April 2021 at 10:00 hrs PDT
What is th...
Hello Admin Community!
I’m recruiting participants for an upcoming study looking at large meeting troubleshooting in Control Hub. If you’d like to participate, please fill out this quick, 2 min. survey. Thanks! https://www.surveymonkey.com/r/...
Don't you just hate having to run RTMT in a virtual machine, well here it runs in an app for mac. I have complied a version for CUCM 14.x ( from a version I got for 11.x ) It works on older versions also. Here it is https://haffi.is/rt...
Ask questions from Tuesday, April 20 to Friday, April 30, 2021
To participate in this event, please use the button to ask your questions
Tour of the Real-Time Monitoring Tool
Have any questions about the Real-Time Monitoring Tool?
What is the...