I'm involved in the following setup illustrated below. I am Site 4. I have a SIP trunk via the CUBE to Site 1. Calls route between Site 4 and Site 1 with no problem. Is it possible to use Site 1 CUCM, to route calls from Site 4 to Sites 3 or 2? Is it...
Hello,Is there any information available about the max Calls per Second the Cisco C8200 & C8300 can handle?
Hello,i've updated a VG310 from 15.6.3M6 to 15.9.3M9.Since then after every reboot "mgcp fax t38 inhibit" shows up in running-config. I don't want that config parameter.After a "no mgcp fax t38 inhibit" and save to startup-config it's gone but after ...
Can I add a comment within a voice-port or a dial-peer and if so how?Something like where I entered "! 2024-04-01 last edited by me"What would be the command to do this?!voice-port 0/0/1! 2024-04-01 last edited by mestation-id name FamilyMedstation-i...
Hello, We are configuring MS Teams calling with Direct Routing. We see that transfers to PSTN are not working. In the INVITE message going to PSTN, we see a Referred-By header, but our provider says that they need a Diversion header to make the tran...
I wanted to run it by the experts so that I have good idea well in time. Apologies for the lengthy background. Following is my current scenario: - 2 sites (Hq and Branch) connected by MPLS- Single CUCM 12.5 cluster with nodes spread in both sites- Hq...
Hello team,We have a router C8200L and we would like to use it as a voice gateway.And we would like to use a SIP conncectivity with the telecom operator.We would like to know what is the requirements (licence on router side, ...) we have to get.Thank...
Customer has a gateway running MGCP. Gateway has an FXO card in it. One of the ports has started acting strangely. Inbound callers to the number just hear ringing. The phone will ring 3 times and then simply stop. No forwarding set up on the ph...
I need to change the IP on an MGCP VG 310 but can't find documentation that tells whether any changes need to happen on the Gateway section in UCM. Could someone point me to the documentation on this or let me know about any required changes in CUCM?...
Hello, my customer wants that outgoing calls from CUBE are identified with different numbers from a pool. The incoming call comes into the CUBE with always the same identification (calling number), so I can't map with translations rules to manipulate...
Hi all,We had implemented Teams direct routing setup with a pair of CUBEs in High Availability mode (about a year ago) and the certificate (sbc.mydomain.com) is about to expire. I would like some help on the steps required to renew the certificate, b...
Hi, The local fire department which also provides ambulance service has a direct line which they tell us to use as the response time is faster for 911 calls. I would like to know how to accomplish this on the CER server any directions or documentatio...
Hello,I'm having issues with the outbound calling between our ISR 4331 and a SL-100 phone switch. Whenever we try to dial a seven digit number from our Cisco phones, we get a busy tone; however, phones attached to the SL-100 can call us. The legacy...
We installed new fax machines. After doing so, fax machines will intermittently call out to the location operator on their own. Can someone advise how to troubleshoot this and block the fax machines from calling internal numbers. Any assistance doc...
Hello All, We have the below outgoing dial peer configured on our CUBE (ISR4331 - Cisco IOS XE Software, Version 17.06.05) which has in the past forced out a number prefixed with 546914 to our service provider with the CLI hidden. This has worked up...
