Unified Communications Infrastructure

we have a Unity server (4.0(3))that runs high memory mapping gradually in a month or two. Then, reboot will make the server back to normal and then, we have reboot again.Does anyone have idea why this memory high happens once a couple of months ?than...

Hi:I have unity 4.2, vm-only at two sites. Am trying to set up smtp netwroking between them. When I fwd a msg to other site I'm getting a reciept saying msg could not be delivered due to routing problem.How can I tell if message got to remote unity?A...

Is it possible to use IP Communicator with NAT. We can attach to the admin page via https but phones will not register.Thanks,Joe

Hi.I'll be upgrading a Unity UM Box running 4.0(5) to 4.2(1) on same box. Do I need to update the schema master on the AD? The reconfiguration and upgrade guide of 4.x mentions that but I'm not sure if it does changes to the AD after the 4.0(5) chang...

I have a customer in Columbia who needs an ATA. I know what the differences between the models are. Has someone tried this in South america.The circuit is an E1

On Unity 4.0.4 sr1 sometimes when callers call in they are getting a "sorry, that is an ivalid entry" error when entering a DN. They get to the call handler prompt OK, but sometimes they get that error. If they call right back, the same DN will g...

I have confirmed that the voice mail ports and the number it is trying to dial is in the same partition. All ports are currently registered with Call Manager.This is a 4.2.1 Integration with 5.1(2)Call Manager

Hi,I have CCM 4.1(3) with A LOT of DNs coming up when I do RoutePlan Report and filter by Unassigned DNs.Can I freely delete those without impacting production setup?David

Hi All,I have a CCM5.1.2 Cluster without CUPS. I am wanting to use CUPC on desktops for call control etc...The issue is authentication see below:2007-09-12 14:28:38,846 [0x120] DEBUG LCMiddleware - Service::Start() - Service[ConfigurationManager], cu...

I've opened a TAC ticket already, but I'd like to know if anyone has run into this. The IBM x3250 is configured with the same hardware requirements as a cisco MCS7825I but the install procedure throws " Installation Error Unsupported Hardware" error....

Hi all, Nice quick one can you controll call flows within the CME other than hunt groups.ThanksPaul

I am trying to login to PCA for the first time, and i keep getting access denied. I am useing my AD username and the password the i use to log into my VM from my phone. Is there some where i need to enable PCA access? I am using Unity 4.2(1)

Hi,I have a hunt group which has suddenly started being constantly engaged. I have tried to reset the huntgroup to no avail. The only other thing i can think to do is restart the TCD service. The CM version is 3.3.RegardsKev