Unified Communications Infrastructure

Hi,We have problems with the BBDD in the CUCX cluster. It is a cluster with 2 CUCX servers, CUCX1 (main) and CUCX2.The CUCX servers System version is 8.5.1.10000-37.The problem is resolved with a restart of the CUCX cluster, but the problem appears a...

The Netapp storage failed on our Flexpod.  This caused the CUCM (and all of the other applications) to run in memory.  In this state we had no call flow.  Since the subscriber was not actually down they did not failover to a working subscriber.  Is t...

Question.  Whats the best way to apply CA Approved certs into the call manager cluster? We are not running DNS but will need to enable it for a Jabber migration in the future.  Right now we need to apply CA approved certs into our cluster. Should we ...

Dear AllNow we try to do performance report for CUCM cluster and I try to use PRTG tools.Please suggest me for configuration about CUCM integrate with PRTGWe would like to monitorCPUMemoryDiskNetwork Thank you

Hello, I will integrate expressway in existing CUCM version 10.5. According to the matrix compatibility, we are asked to install version 8.2.1 for expressway as a recommanded version. Our question is, if i insall the version 12.5 expressway, is this ...

Hello all ,  I have 3 trust certificates of Callmanager-trust DSP1 ,DSP2  and AS5400 expired in cucm 11.5. I would to solve this situation . can you help me please ! Best regardsAkram 

Good day! The  CISCO-VOICE-DIAL-CONTROL-MIB has a branch with Trunk Utilization by Interface:A snapshot of call active statistics per interface is given by the cvCallVolIfTableEntry1.3.6.1.4.1.9.9.63.1.3.8.5.1.1 (array) - cvCallVolMediaIncomingCalls ...

I am looking for a MIBs that can report on various dial-peer configuration items on CUBE's. Following this document, I found the following OIDS:DIAL-CONTROL-MIB::dialCtlPeerCfgOriginateAddress CISCO-VOICE-DIAL-CONTROL-MIB::cvVoIPPeerCfgSessionTarget ...

Hi all I have issues when I try to dial via my ISDN gateway 2911 I dont see the call get to the gateway, if I do a trace via cucm it shows that the calls is getting to the gateway.controller E1 0/0/0clock source internalpri-group timeslots 1-30sccp l...