Hello, I am facing a problem during CUC 12 installation
Memory limit doesn't accept the navigate value and the console show operating system not found
check attached
hello to all,
i am facing a problem with upgrading Cisco unity 10.0.1 to 10.5.2 (su7).
i am receiving this message :
The machine could not sync the inactive version to the active version. Please verify the inactive version was properly installed ...
Hi there,
I am new to Collaboration and the set up. We are busy deploying Webex Teams/Meetings within our company. We used the Webex Teams app free version and then converted it to the paid version.
It's my understanding that we need to have an ...
Hi
I need to update the Q-Value settings within the CUSP server group.
I've not played around with CUSP and wanted to understand if in doing so I would need to reset the SIP trunk in callmanager? Basically will an outage occur (presume all configurat...
HI,We have got a lot of Siemens OpenStage 15 HFA from a closed office. These are supposed to be VoIP telephone sets.I was trying to configure them to use with Cisco because I'm unable to find out MAC addresses of these things.I had tried to look up ...
Hello Folks,
I have a scenario where I have an 11.x CUCM/IMP cluster and a 10.x CUCM/IMP cluster moving into the same domain. We would like to do IM&P intercluster peering to allow users of each cluster to see presence of users in the other cluste...
I am having some trouble understanding the reasons why when a phone roams between locations but the configured associated Device Mobility Group is the same as the home group, that the Device Mobility Related settings are applied. And in contrast, whe...
Hello, I am having CUCM 8.6 on MCS with IP address x.x.x.x and I will migrate and build a new CUCM 11.5 on UCS
I want to install new one offline with the same IP address x.x.x.x then switch network cables to go live
My question is I want the new one...
Hi All,
Inbound calls to my gateway are not working. I ran a debug Q931 and receive an error: Cause i = 0x8083 - No route to destination
I've checked the SIP binding, significant digits on gateway has been set to 'All'. Inbound CSS is set in accord...
I just installed Attendant Console 8.6 and it seems to have gone well but when I log on the client it tells me the extension I used it out of service and I won't be able to make any calls.The extension is working fine on a phone. Any ideas?
We have an issue with the operator console giving an error, regardless of the user or extension, saying that the extension is out of service. We've rebooted the phone, rebooted the server the attendant console runs on and browsed through the setting...
Hello, I watched Jaime Valencia videos about migration but I have many questions about PCD and other scenarios
Note: The environment isn't big
1- I want to backup data from old CUCM and install 8.6 on new UCS then restore data and upgrade with OS adm...
I have about of 5 people that were all recently added get the following when attempting to check there voice mail "Searching, there was an error displaying your message" After this the can get to message from off net but not from on net calls. All ...
Hi To everyone,
Recently we have purchased some cisco VoIP phones from a third party, i would appreciate if someone show me how to verify the if the phones are brand new and genuine cisco products.
Regards
I have a Call Manager 9.1.2 installation with all phones auto registered (using device mobility) and all the users enabled with extension mobility. This is great because phones only need to have extension mobility enabled before they can start b...
