cisco call manager issue

[CSCO11662653]

how to apply newly added or edited route pattern to Cisco Unified CM Administration

[Mohammed Khan]

Map the route pattern to Route List/Trunk/Device.

Refer below link

http://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified-communications-manager-callmanager/6361-dp-isdn-gateway.html#Topic2

[CSCO11662653]

i just edited the existing route pattern to add a new number and saved .All other (Route Partition,Route Class,Gateway/Route List) are same.After that also when i call the new number pattern it is not dialling.in the screen shot to the existing numbers i had added the new 0054XXXXXXX.

[Mohammed Khan]

Can you grab DNA report

[Jaime Valencia]

You don't have to do anything when you change anything in your dial plan, CUCM will start using the new info right after you hit save.

You need to troubleshoot this as any other dial plan issue, start by looking at the config, CSS, partitions, etc.