cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
433
Views
5
Helpful
2
Replies

configure autodialer from gateway

waldronks
Level 1
Level 1

I have a phone in an elevator which needs to be configured to automatically ring to an outside line when the phone is picked up. I'm using CUCM 8.0 and prefer assistance using GUI instead of CLI. 

2 Replies 2

yahsiel2004
Level 7
Level 7

Configuring Private Line Automatic Ringdown (PLAR)

You can configure Private Line Automatic Ringdown (PLAR), so when the  user goes off hook (or the NewCall softkey or line key gets pressed),  the phone immediately dials a preconfigured number. The phone user  cannot dial any other number from the phone line that gets configured  for PLAR.

PLAR works with features such as barge, cBarge, or single button barge.  If you use PLAR with a feature, you must configure the feature as  described in the feature documentation, and you must configure the PLAR  destination, which is a directory number that is used specifically for  PLAR.

The following example describes how to enable PLAR functionality for  phones that support barge and that are running SCCP and SIP. A and A'  represent shared-line devices that you configured for barge, and B1  represents the directory number for the PLAR destination. To enable PLAR  functionality from A/A', see the following example:


Tip Step 1 through Step 4 apply if you want to configure PLAR for phones that are running SCCP. For phones that are running SIP, you must perform Step 1 through Step 6.  Before you attempt to configure PLAR, verify that your phone model  supports PLAR. To determine whether your phone supports PLAR, refer to  the Cisco Unified IP Phone Administration Guide that supports your phone model and this release of Cisco Unified Communications Manager.


Example for How to Configure PLAR


Step 1 Create  a partition, for example, P1, and a calling search space, for example  CSS1, so CSS1 contains P1. (In Cisco Unified Communications Manager  Administration, choose Call Routing > Class of Control > Partition or Calling Search Space.)

Step 2 Create  a null (blank) translation pattern, for example, TP1, which contains  calling search space CSS1 and partition P1. In this null (blank)  pattern, make sure that you enter the directory number for the B1 PLAR  destination in the Called Party Transformation Mask field. (In Cisco  Unified Communications Manager Administration, choose Call Routing > Translation Pattern.)

Step 3 Assign the calling search space, CS1, to either A or A'. (In Cisco Unified Communications Manager Administration, choose Device > Phone.)

Step 4 Assign  the P1 partition to the directory number for B1, which is the PLAR  destination. (In Cisco Unified Communications Manager Administration,  choose Call Routing > Directory Number.)

Step 5 For phones that are running SIP, create a SIP dial rule. (In Cisco Unified Communications Manager Administration, choose Call Routing > Dial Rules > SIP Dial Rules. Choose 7940_7960_OTHER. Enter a name for the pattern; for example, PLAR1. Click Save; then, click Add Plar. Click Save.)

Step 6 For  phones that are running SIP, assign the SIP dial rule configuration  that you created for PLAR to the phones, which, in this example, are A  and A'. ((In Cisco Unified Communications Manager Administration, choose  Device > Phone. Choose the SIP dial rule configuration from the SIP Dial Rules drop-down list box.)

HTH

Regards,

Yosh

HTH Regards, Yosh

That's exactly what I needed.  Thank you very much!!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: