10-28-2009 08:14 AM
Hi!
Where do I configure outgoing callerID for a bunch of numbers in Callmanager 6.1?
Thank you in advance!
10-28-2009 10:11 AM
You configure it in several ways:
A) Configure the external phone number mask under each DN and check the use external party mask checkbox under the route patterns to use it
B) Configure it under the route pattern as calling party mask
C) Configure it at route list level as calling party mask
D) Configure it at GW/trunk level
The most common methods are A and B, C is mostly used then doing failover from ICTs to a PSTN GW.
Jaime Valencia
PDI Engineer
www.cisco.com/go/pdihelpdesk
10-29-2009 08:14 AM
Thank you for the list, perfect!
I was the route pattern transform mask that needed changing!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: