cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1395
Views
0
Helpful
2
Replies

Critical error installing Call Manager 7 on VMware 6.5

sunil suthar
Level 1
Level 1

I am trying to install Cisco Unified Communication Manager 7.0.1 on Vmware 6.5.1 for lab purpose. I am trying to use this as 'host' only (not NAT) to be used on my laptop.

Vmware installed successfully, while installing new machine I use the following configuration:

2GB RAM

80 GB HD

1 processor

For the Network Adapter I tried using Host only and custom (VMnet-1)

Here is my IP configuration

VMNet1 : IP: 192.168.1.101/24

GW: 192.168.1.25

For the CUCM I tried IP: 192.168.1.25/24

GW: 192.168.1.101

to make the CUCM work on my machine.

I proceed with basic installtion (no dhcp, no dns, no ntp)

While installing I get a network error that could not connect to the GW. If I review and process further I get the Critical error message as attached in the screen.

Here is my machine's configuration: 4GB RAM, 500 GB HD, AMD A6 (Dual core)

Thanks

2 Replies 2

ronpatel
Level 8
Level 8

Hi,

Plesae note CUCM 7.X is not supported in ESXi or any virtuliased environement.

Also while installing CUCM, make sure ou have default gateway IP address reachable. If you want create some ip address which is reachable and assign it as default gatewa.

Regards

Ronak Patel

Rate helpful posts.

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.

amsaini
Level 1
Level 1

What happens if you select "bridged" option in VM? That worked for me. Moreover I agree to what Ronak has said.

Sent from Cisco Technical Support iPad App

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: