Occasionally, messages cannot be delivered to the recipient that the caller intended to reach. The system behavior in this case depends on the type of sender and the reason that the message could not be delivered.
In general, if Connection cannot deliver the message because of issues that are not likely to be resolved (for example, the caller was disconnected before addressing the message, or the recipient mailbox has been deleted), the message is sent to the Undeliverable Messages distribution list, and Connection sends a nondelivery receipt (NDR) to the sender.
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...