05-30-2011 10:09 PM - edited 03-19-2019 03:01 AM
i just have done shutdown and up cucm 8.5 . and it doesnt work second sub scriber. i designed one pub and two sub. plz your replies
Sent from Cisco Technical Support iPhone App
Sent from Cisco Technical Support iPhone App
05-30-2011 11:02 PM
hi,
From the problem description it looks like you rebooted your pub and two subs, It failed on one of your sub (snap shot attached).For some reason the file system of the system is corrupted, it might be a result of improper shutdown.
Boot the server from recovery CD and perform a file system check. In most cases it will fix the problem.
-Atul
05-30-2011 11:57 PM
thx . i will perform your opinion
and dont you have any guide ?
Sent from Cisco Technical Support iPhone App
05-31-2011 04:37 AM
hi,
Below link has steps to perform file system check for CUCM 7.1.3
http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080b1f305.shtml
Steps for CUCM 8 should be somewhat similar.
- Atul
If this helps, please rate
05-31-2011 09:51 AM
05-31-2011 06:02 PM
Hi Myung,
"IPMA Application not started" . This alert should not be present on the CLI, it should be logged into syslog.
Please go ahead and open a TAC case.
- Atul
Please rate, if this helps.
05-31-2011 07:32 PM
thx for your help =)
Sent from Cisco Technical Support iPhone App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: