CUCM - CONDUCTOR - MCU not Working (BUSY)

[thorstenn]

Hi,

I try to configure CUCM with Conductor and a single MCU behind but for some reason its not working. The call is reaching Conductor (Call History) and also MCU (SIP Event Log) but in MCU LOG i see this:

In CUCM Traces i see forbidden, but why:

Conductor:

Any suggestions?

Cheers

[Trad Tobaishat]

The MCU screenshot showing it recieved the Cancel message. What is the source of this message?

I can check the logs for you if have them.

regards,
Trad

[thorstenn]

AFter setting the SIP trunkt o non secure its working. But its different from the deployment guide:

http://www.cisco.com/c/dam/en/us/td/docs/telepresence/infrastructure/conductor/config_guide/xc3-0_docs/TelePresence-Conductor-Unified-CM-Deployment-Guide-XC3-0.pdf

Page 40

Task 27
Task 28

Here its clearly written we should set this to secure.

But if the Endpoint/Client is not secure it seems we got a 403 Forbidden.

[xiexiaolei]

I encountered the same problem, the solution found yet?