CUCM Sub Node - Backup Restore

[silvervoip]

Hi Team,

Quick question. As my LAB is not accessible today, I would like to have your help here.

I need to re-build 1 CUCM sub node and add into existing cluster. Once this server is built and part of the cluster.

How can I restore the backup only for this Sub node? Cisco's official documentation made me little bit confused.

CUCM:11.5

Thank you.

[Nithin Eluvathingal]

What I Understood  you are trying to add a new sub from some backup.  Why do you need to restore the backup for this scenario. if its only sub, you can do the below.

If this node  was a part  of the  cluster remove it  and add it again. then start the installation of the sub. 

[silvervoip]

Hi,

Node must be re-build with higher hardware capacity. Existing node is too old and we cannot increase the hardware. We have confirmed this with TAC a couple of weeks ago. We have been planning to power off & increase the RAM, HDD etc but unable so only option is rebuild and restore the backup

[Nithin Eluvathingal]

would you mind explaining your setup and scenario which you are trying to achieve  in details.

[Roger Kallberg · Accepted solution]

In the DRS restore wizard you can select the node that you'd want to restore.