cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
243
Views
0
Helpful
1
Replies

CUE is not communicating with Fast Ethernet as service engine interface

Anupam Singh
Level 1
Level 1

Hi,

I have got Cisco 2811 CME router and CUE module integrated in it. Fast Ethernet 0/1 is connected to switch and further to IP Phones. if i assign IP address directly to service-engine 1/0 then it works fine and be able to ping service-module of unity connection express. Both service-engine and service-module are kept in same subnet. 

int service-engine 1/0  

ip address 10.10.10.1 255.255.255.0

service-module ip add 10.10.10.2 255.255.255.0

service-module ip default-gateway 10.10.10.1

no shut

 

CME(Config)#ip route 10.10.10.2 255.255.255.0 service-engine 1/0

 

the above configuration works ok to get enter into CUE interface and configuring mail box.  But If bind fast ethernet 0/2 interface of router with service-engine by using command #ip unnumbered fa0/2 and assign IP address to this then it does not able to ping CUE module that's why I cant access CUE module to configure mailbox. The following configuration did as follows:-

int service-engine 1/0  

ip unnumbered fast ethernet 0/2 ip address 10.10.10.1 255.255.255.0

service-module ip add 10.10.10.2 255.255.255.0

service-module ip default-gateway 10.10.10.1

no shut

CME(Config)#ip route 10.10.10.2 255.255.255.0 service-engine 1/0

By using above configuration, I am not able to access CUE module. I have got switch and ip phones connected to Fast ethernet 0/1.100 interface with different subnet i.e. 10.10.20.0 /24 network. 

Could  Anyone help please?

 

Thank You

Regards

 

 

 

 

1 Reply 1

Terry Cheema
VIP Alumni
VIP Alumni

Hi Mate,

Refer here and match your config with these docs:

http://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/software/feature/guide/ism-sm-sre.html#wp1056674

http://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/software/feature/guide/ism-sm-sre.html#wp1056674

If it still doesnot work - Please attach your config and also output of: service-module ism 0/0 status

-Terry

Please rate all helpful posts

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: