hi we have the cup8.6, cucm 8.6 integrated to OCS for RCC.
All dashboard and system checks on cup are ticked ok. However on user MOC client we get the following error : 'cannot connect to the phone system, the call control server may be temporarily unavailble' .
we have trunk from ccm to cup, in cup we have ACL's for OCS and in cup we have cti gateway and ctigw application user with 8 cti cucm's.
User was on a cup 7, with ccm 7 to same ocs and all worked fine, issues after migration to ccm 8 . Move user back to ccm 7, i.e. register the phone to old ccm and using cup 7 all works fine again.
SIP is easier to make redundant. If there is more than one physical cable to the provider, then SIP can be reserved in three ways at L2, it's the Portchannel, STP and the Fex link, the same as RTG from Juniper. CUBE routers can also be reserved for ...
b+s brings Lightning to the forefront of the Salesforce Experience this summer by adding the ability to route and report on Salesforce Omni-Channel interactions.
b+s continues a product strategy of providing access to the full suite of native Sales...
11. September 2018 | Happy Landings | Frankfurt DE
Chatten Sie schon oder telefonieren Sie noch? Die digitale Kundenreise bringt den Chat-Kanal mit künstlicher Intelligenz in eine prominente Position. Nehmen Sie teil am Flug durch die Möglichkeiten des...
Collaboration Product and architecture introduction-CUCM Part(7/30)
A system has a 2 way divisible room with two SX80s. When the rooms are combined, only one codec will be used. User does not want a notification message displayed on the secondary Touch10.
Is there a method to lockout control of a Touch10 to pre...