So, the CUBE thinks it’s a new call and will not send the new invite with authentication, so I have to make a SIP profile to remove the portnumber in the Call-id Not sure if that gives any other problems. Has anyone seen this before.? Is there another solution.?
In the document they are stating that they do support session refresh but when that is enabled, we can´t dial around 10 – 15 % mobile numbers. When we confronted the Telcon the answer was you should not put the require:timer on those calls were it isn´t in the “supported list”. And when I remove the session refresh we are able to call all numbers but then we get timing issues, calls disconnect.
Before they where running with a Innovaphone system with the same SIP trunk without problems.
So, my question is do any one in here have knowledge about running Deutsche telekom SIP trunk with CUCM.?
on January 25th and 26th, we're hosting a Technical Enablement Workshop which will guide you through the steps involved in updating your organisation from Jabber and/or Meetings to Webex App.
Very useful for partners and for customers t...
hi Team, we are planning to deploy Multi-Factor Authentication for Jabber. The main requirement is to use MFA over internet (MRA).Is it possible to deploy MFA just for MRA and don't touch impact any on-prem existing setup?Can someone please guide on ...
Looking to expand your professional network? Interested in gaining an edge with exclusive technology insights? Engage with Cisco experts, share feedback on products and connect with peers from across the globe. Cisco Champion 2021 applications are open fo...
UCCX does not natively protect HTTP Triggers.
I wanted to come up with a solution to handle HTTP cookie based authentication.
There is a zip file for this project attached to this article. It was written on UCCX 12.5...