cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
577
Views
0
Helpful
2
Replies

Dial-peer

Shri2
Level 1
Level 1

As we know we have E164 pattern map command to have multiple patterns in one dial-peer.

 

destination e164-pattern-map 110

 

Do we have similar command for incoming called number ?

2 Replies 2

Create your pattern maps using the "voice class e164-pattern-map #" command. Then you can apply the pattern map to either incoming or destination numbers.

incoming called e164-pattern-map 1

destination e164-pattern-map 2

Note that it says 'e164-pattern-map' but the numbers can be any kind of pattern not just e164-formatted patterns.

Maren

thanks for the response. I see incoming called e164-pattern-map 1 is available ONLY for VOIP dial-peer as per below doc,
the same command is not available for POTS DIAL-peer :( , Does anybody have any idea whether cisco would be including this feature in newer IOS version ?

https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/dialpeer/configuration/15-mt/vd-15-mt-book/vd-mdp-dialpeer.pdf
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: