cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
8319
Views
0
Helpful
0
Replies
Highlighted

E1 PRI conected to from Digital PBX to CUBE.

Hi everyone.

I have to connect three PRI lines between Digital PBX and CUBE, so I have to configure the serial ports as Service Provider. I check in Cisco and I found this post talking about it.

https://supportforums.cisco.com/t5/collaboration-voice-and-video/how-to-configure-network-side-isdn-pri-signaling-for-pbx-in-a/ta-p/3133212

The PBX is currently connected to SP, so I asked to SP the PRI details (channel number 30, line coding HDB3, Framing CRC4)

I've configured the getway taking acount all this information.

!

isdn switch-type primary-net5

!

trunk group PBX

hunt-scheme sequential

!

controller E1 0/0/0

pri-group timeslots 1-31

!

interface Serial0/0/1:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn protocol-emulate network

isdn incoming-voice modem

trunk-group PBX

no cdp enable

!

That would be enough or I need to cosider anything else?

Thank you

Best Regards

Everyone's tags (3)
CreatePlease to create content
Ask the Expert- Webex Hybrid Services Solutions