cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
302
Views
0
Helpful
1
Replies

Extension Mobility on the DX series

Tim Cappel
Level 5
Level 5

I was under the impression that the DX series endpoints support extension mobility, however after enabling the devices and verifying our cluster has EM working appropriately, the EM option still isn't showing up on the DX's.  The release notes for the code we are on which is one behind the current, .46, doesn't say anything about EM not being supported.  I tried with 2 different DX's (650 and 70) and verified EM was working on an 8945 and 7900 series.  Could someone confirm that it should in fact work, and give any information regarding any gothca's? 

Thanks,

Tim

1 Reply 1

Manish Gogna
Cisco Employee
Cisco Employee

Duplicate of the following post

https://supportforums.cisco.com/discussion/12601056/extension-mobility-dx-series#comment-10772811

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: