01-12-2010 11:43 AM - edited 03-19-2019 12:16 AM
Is there a way to configure the SNMP trap service (if there is one) on UCM 6.1?
Thanks!
Chris
Solved! Go to Solution.
01-12-2010 11:53 AM
Yes, under serviceability
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/service/6_1_1/admin/sasnmdes.html
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
01-12-2010 11:53 AM
Yes, under serviceability
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/service/6_1_1/admin/sasnmdes.html
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
01-12-2010 12:38 PM
Thanks! Is there a way to test it easily? I have gone through all of the steps but our monitoring system doesn't seem to be getting them.The guy in charge of it says his side is set up correctly.
01-12-2010 06:33 PM
The config is really straight-forward, not sure if there might be some service related to this.
I'll check that tomorrow
Have you checked nothing is blocking the SNMP traffic from CUCM?
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: