cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

I need a help in stting up my Lab for SAF

rupam_chakra1983
Beginner
Beginner

Hi

I have a two 11.x CUCM cluster,and i am trying to deply SAF  between thecluster,I am using a cisco 2811 router with 15.1x ios image as a forwarder

But this router.

I have configured both the cucm and the Router for SAF but when run the command show eigrp service-family external-client cannt get anything.

Also when i do debug eigrp service-family  cannt see any output.

here is my router config

router eigrp saf
 !
 service-family ipv4 autonomous-system 20
  !
  topology base
   external-client admin
  exit-sf-topology
 exit-service-family
service-family external-client listen ipv4 5050
 external-client admin
  username cluster
  password ciscocisco1

The xmcp protocol command is not there in this router

:c2800nm-adventerprisek9-mz.151-4.M10.bin

Any support appreciated

1 REPLY 1

rupam_chakra1983
Beginner
Beginner

Any help appreciated

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: