12-18-2013 08:49 AM - edited 03-19-2019 07:40 AM
We need to move some phones from CUCM to CME. Below is the configuration of a phone in CUCM. How should we set it up in CME since there is no concept like partitions. We would want to use the same number 2947760 on the 7914 addon module on almost every line.
We need to set up the side card of 17 phones with the same settings and is there a way to automate this process?
Calin
Solved! Go to Solution.
12-18-2013 09:40 AM
Hi Calin,
As Chris nicely noted, this type of config is a tad "old school" (+5 "C") but some of
our users prefer the visual "line per button" aspect of this as well
In CME you can approximate this setup with Overlaid DN's and the x keyword
as shown here;
Cheers!
Rob
"When it comes to luck you make your own "
- Springsteen
12-18-2013 09:20 AM
There is a concept of CSS/PT in CME it is called COR lists.
The question here is why do you want the rollovers since CME supports octo DNs?
The rollover config in CUCM was a concept on CUCM versions prior to 4.0 (years ago) where call waiting (busy trigger) was not available and this was the only way to get more than 1 inbound call per phone.
HTH,
Chris
12-18-2013 09:40 AM
Hi Calin,
As Chris nicely noted, this type of config is a tad "old school" (+5 "C") but some of
our users prefer the visual "line per button" aspect of this as well
In CME you can approximate this setup with Overlaid DN's and the x keyword
as shown here;
Cheers!
Rob
"When it comes to luck you make your own "
- Springsteen
12-18-2013 11:53 AM
The users want the "line per button". They are used to use the phones like this.
Thank you for your help. We'll read the documentation and come up with a solution for this. That link is a good start for us.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: