Solved: Maximum sessions with LTI transcoder on CUBE

M02@rt37 · ‎10-01-2018

hi experts,

I have a question about CUBE LTI transcoding configuration.

When you configure your transcoder you specify the maximum session 《XX》.

This value 《XX》 is calculated and depend on the dsp ressources (which type of PVDM card)? Or is it anything else?

Thanks very much.

Best Regards

Best regards
.ı|ı.ı|ı. If This Helps, Please Rate .ı|ı.ı|ı.

Jaime Valencia · ‎10-01-2018

It depends on the amount of DSP resources, and the codecs to be used in the profile, lower complexity = more sessions, higher complexity = less sessions. If you use universal transcoding, that also takes more resources.

HTH

java

if this helps, please rate

View solution in original post

Jaime Valencia · ‎10-01-2018

It depends on the amount of DSP resources, and the codecs to be used in the profile, lower complexity = more sessions, higher complexity = less sessions. If you use universal transcoding, that also takes more resources.

HTH

java

if this helps, please rate