cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
409
Views
5
Helpful
2
Replies

Message Setup

scooter817
Level 2
Level 2

Hi Everyone

Can you anyone tell me what determines which CM sends the setup message to the gateway?

2 Replies 2

paolo bevilacqua
Hall of Fame
Hall of Fame

Yes using debug commands.

Tim Smith
Level 4
Level 4

Debugs will definitely tell you what is really happening.

If you want to know from design point of view. Check out the srnd guides.It is dependent on CUCM version, route list config, gw protocol, direction of call, where your phone is registered.

In particular look up run on all nodes. Nice new feature for optimizing this.

Cheers,

Tim

Sent from Cisco Technical Support iPad App

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: