Need to troubleshoot Unity 7 / Exchange 2010 communication
Last night I went through the procedure of integrating an Exchange 2010 server into an existing Unity 7 environment (using the well-known Cisco documentation - scenario #1 "Adding One or More Exchange 2010 Servers to an Existing Cisco Unity 8.0, 7.0, and/or 5.0 Installation"). It did not go well. After running through all of the procedures, we moved a single mailbox over to the 2010 server. Any attempt to leave a voice message results in the message stacking up in the UnityMTA folder. My question: what micro and macro traces would be most useful in troubleshooting communication issues between Unity 7 and Exchange 2010?
I would start by running permissions wizard in reporting mode to make sure you don't see any errors. What does the event viewer logs on Unity look like? Do you see any other errors such as MALEx or DoH? Is this a new intergration or has this been partnered with any other version of exchange before?
The traces I would look at are as follows:
No Macro traces, Micro should tell us enough for this.
I understand your question is towards traces for troubleshooting,however, it would be good to make sure of certain steps that normally people fail to configure:
1-On the well known guide you stated, people usually put in verbatim the following command on the Exchange power shell: set-mailbox -identity "UnityMsgStoreSvc" -throttlingpolicy "Unity Exchange 2010 Policy"
What happens is that some times they set a different name for the UnityMsgStoreSvc, for example MsgStoreSvc, UnityLondonMsgStore and so on, therefore it would correspond to the change the command with the actual Message store account name, instead of the one in the example.
2- Sometimes the MAPICDO does not install properly, therefore double make sure by running the latest GUSI v.2 (Gather Unity System Information), and make sure that it is displayed. If this is the issue you may want to check the following:
Greetings, Wanted to share a few lessons learned while migrating from a distributed to centralized IMP deployment. Our current setup included many CUCM/IMP distributed clusters with centralized Expressway server for MRA login. We did not wish to perf...
Parsec's Cisco UCCE/PCCE CC Connector application for CRM works as a bridge between the CRM and Cisco UCCE/PCCE CC solution.The CRM can be any cloud based CRM like Salesforce (SFDC), ServiceNow ,MS Dynamics or a 3rd party CRM.The CRM user/Agent will have ...
It’s a feature which allows CUCM to determine whether the phone is in its home location or a roaming station.By enabling this feature users can roam from one site to another site and acquire the site-specific settings such as Codecs, MRGL, Call rout...
Cisco just Announced their new Collaboration Toolbox resources portal. You can check it out here https://collabtoolbox.cisco.com/ It has a bunch of tools a partner can find helpful. But if your interested in learning which...