cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
877
Views
0
Helpful
2
Replies
Highlighted
Beginner

No associated devices to restart

Hi, I have CUCM 9.1 connected to CUP 9.1. My Jabber for iPad client authenticates to presence and cucm successfully. I can call and get video when dialing extensions directly, but users do not show up in my directory and when viewing from presence server my status for Jabber shows "Logged out". Also, when in CUCM I apply the UC Service or Service Profile and get "No associated devices to restart". The following steps have been confirmed. Thanks for your help.

In CallManager webpage:
- On End User page, is Enable User for Unified CM IM and Presence checked, UC Service Profile defined, and TAB device added to Controlled Devices? Yes

- On Phone Configuration page for TAB device, is your end user defined on Owner ID and Digest User? Yes
- On Directory Number configuration for TAB device, is your end user associated with line at the bottom of page? Yes


In CUPS webpage:
Under User Management > Assign Users > Has your End User been assigned to Presence? Yes

2 REPLIES 2
Highlighted
Hall of Fame Cisco Employee

No associated devices to restart

It sounds to me you're using it on voice and video mode, and not on full UC mode

See table 3

http://www.cisco.com/en/US/partner/prod/collateral/voicesw/ps6789/ps6836/ps12430/data_sheet_c78-704194.html

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate
Beginner

No associated devices to restart

Thanks for your help! Looks like it, but when I log in from  Jabber for iPad both the Unified Presence and Unified Communicatoins Manager sections are successfully authenticated. Only other tabs are WebEx Messenger, Telepresence Cideo Communication Server and Jabber Video for Telepresence.

CreatePlease to create content