cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
520
Views
0
Helpful
0
Replies
Highlighted
Beginner

No Auto-Line after missed call

We currently have 6921 and 7962G phones setup in a parallel hunt group. I tried to set the ephones to "no missed-calls" since it was causing headaches for the end users by having it show the missed calls even though someone was answering it.

It was noticed that if a call comes into the hunt group and it is not answered, the caller id data on the 6921 phones stays displayed on the phone with a blinking phone symbol next to it. If you try to make a call outbound with that there, the phone will not automatically grab a line. You have to exit out of the display showing the caller id data or press a line button to get dial tone and when you do that, it goes to the speaker phone and not the handset even though the handset is offhook.

The 7962G phones are not affected by this and work as they should whether "no missed-calls" is configured on the ephones or not.

What is causing this? Is it some sore of known bug or is there a different phone load that addresses this? The 6921 phone are currently using SCCP69xx.9-0-3-a.loads.6921.JPG

0 REPLIES 0