Having a problem with a lack of ringback on transfered calls from the PSTN
Call flow is as follows
PSTN > FXO port on 2811 router > SIP Trunk > CUCM
when transferring internal calls ringback works as expected
when transferring calls from the PSTN between internal DNs the caller hears MOH while the transfer number is entered and then silence until the called phone picks up
I have searched the forums for a solution but can only find issues relating to h.323
Please post the configuration of your router. Also, provide below information:
1. Is this issue happening for both blind transfer and consult transfer?
2. What is the version of CUCM?
3. What is the Phone Model and Protocol used?
1. During consult transfer the PSTN caller hears Music On Hold whist the "transferer" calls and speaks to the destination extemsion. I believe this is to be expected.
During blind transfer the PSTN Caller hears silence while the extension is ringing
2. CUCM version is 188.8.131.5200
3 Phone models are 8945 using SCCP
Voice Gateway config is attached
Please try any of these solutions:
Configure the voice call send-alert Cisco IOS global configuration command in the terminating gateway/router.
This command enables the terminating gateway to send an alert message instead of a progress message after it receives a call setup.
Upgrade the Cisco IOS Software on the originating gateway/router to latest Cisco IOS Software Release.
Thanks for your suggestions
Ive added the voice call send-alert config. As far as I can tell this has had no impact.
The IOS version is 15.1(4)M12a. I can't find a more recent IOS.
Once the call is sent to CUCM, it's typically the CUCM that's responsible for providing a ringback tone to the caller on the other end. Make sure an Annunicator is available in the Media Resource Group List of the trunk or gateway. Also, try below configuration changes:
1. Change the following Service Parameter (for Callmanager service) in CUCM and see if that helps:
'Send H225 User Info Message' parameter and set it to 'Use ANN for Ring Back'
2. Try below configuration:
voice service voip sip bind control source-interface Loopback0 bind media source-interface Loopback0 midcall-signaling passthru !
If above configuration doesn't work, please post the logs for "debug ccsip messages" and "debug ccsip events"
In your router configuration, you have set up POTS lines cptone to GB (Great Britain). What is the network locale setup under device pool that is configured for IP Phones and Gateway? Can you try to match it and give it a try?
Also, I see that the codec between CUBE and phone is negotiated to G.729. Can you try setting up G711 codec?
Network Locale is already set to United Kingdom on all device pools
Ive changed the codec to g711ulaw. That dosen't seem to have had an impact on the issue