I have an issue with OCS and Unity. Here is the scenerio: user dials Unity main extension from OCS dialpad. Unity then prompts for ID (exension). user dials extension. Unity error "I did not recongize that tone, please dial ID". user dials extension again. Unity error again, then company's main greeting plays. The reall issue is this only happens with one site. Other sites do not have this problem.
As long as all components are compatible, then the next step is to take a look at what Unity is receiving from the CM. In Tools Depot>Unity Diagnostic Tool, enable these mAcro traces: Call Control and Skinny TSP. Place a call to generate traces, then gather the svchost (for Skinny/SCCP) traces or the AvCsMgr traces (for SIP) that correspond to the timeframe of the test call. If Unity is receiving the correct digits from CM, then I'd suggest you open a TAC case to get help from there.
If Unity is not receiving the correct digits from CM, then I'd suggest setting/collecting/reviewing CM traces to see what is received from the OCS and what CM is sending to Unity.
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...