Added a new Task to upgrade a 9.1.1-20000-5 CUCM cluster to 10.5.1. Already on VMWare 5.1.
However when I add a New Task for Upgrade, I get to Step 4 of 5 where I should see under #4 the Switch Version of CUCM Publisher, it just shows "No Nodes Assigned" like it can't figure it out. Won't let me continue or run the upgrade task.
Symptom: After creating a task with a schedule start time, PCD added one or a couple additional minutes into the start time. This issue was seen on switch version task and the same issue could be seen on other tasks.
Conditions: Schedule for a specific start time when creating a task such as switch version.
hi Team, we are planning to deploy Multi-Factor Authentication for Jabber. The main requirement is to use MFA over internet (MRA).Is it possible to deploy MFA just for MRA and don't touch impact any on-prem existing setup?Can someone please guide on ...
Looking to expand your professional network? Interested in gaining an edge with exclusive technology insights? Engage with Cisco experts, share feedback on products and connect with peers from across the globe. Cisco Champion 2021 applications are open fo...
UCCX does not natively protect HTTP Triggers.
I wanted to come up with a solution to handle HTTP cookie based authentication.
There is a zip file for this project attached to this article. It was written on UCCX 12.5...
CUCM can backup the manually or have sehchduler to backup the configuration and historical reports from the server diester recovery systemStep 1. Navigate to CUCM > Disaster Recovery System > Backup > Manual Backup as shown in the...