cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

1955
Views
0
Helpful
3
Replies
Beginner

Prime 1.3 not showing "Current Associated Clients" for each AP

I have installed PI 1.3. All WLC controllers have been added, as well as switches. All AP's are also showing up, along with all the details. But if I go to "Device Work Center" - Device Details - Device Types - Unified AP - Current Associated Clients (among other areas), no clients are listed, it just says "No data availabale". Same thing in other areas as well.

But all the other information is provided...the "General", Interfaces" and even "Clients over time" show the correct client counts per AP over time. On the "Configuration" tab, all information is shown as well. The only issue is in the one area.

Any suggestions?

3 REPLIES 3
Cisco Employee

Re: Prime 1.3 not showing "Current Associated Clients" for each

This is not the right community for this question. Please post this question under the Network Infrastructure -> Network Management community.

Thanks,
Khurram

Sent from Cisco Technical Support iPhone App

Highlighted
Beginner

Re: Prime 1.3 not showing "Current Associated Clients" for each

Hi,

Did you solve this issue? I'm seeing the same thing.

Thanks,

Cisco Employee

Re: Prime 1.3 not showing "Current Associated Clients" for each

This is not the right community for this question. Please post this  question under the Network Infrastructure -> Network Management  community.

Thanks,

Khurram

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here